Vertex Diagnostics UltraTRAK Manual do Proprietário descarregar pdf (Página 14)

5. Setting the reminder alarm

You may set up any or all of the reminder alarms

(1-4). The meter displays “On” or “OFF” and

, press the M button to turn on or turn off to set the

rst reminder alarm.

These parameters can ONLY be changed in the setting mode.

If the meter is idle for 3 minutes during the setting mode, it will

switch off automatically.

NOTE

Press the M button to select “On”, then press SET to set the hour.

When the hour is ashing, press the M button to add an hour. Press

SET to conrm and go to minutes, press the M button to add one

minute. Hold the M button longer to add faster. Press SET to conrm

and go to the next alarm setting.

If you do not want to set an alarm, press SET to skip this step.

If you want to turn off an alarm, nd the alarm number by pressing

SET in the setting mode, press the M button to change from “ON”

to “OFF”.

At the time of your alarm, the meter will beep

and automatically turn on. You can press the M

button to silence the alarm and insert a test strip

to begin testing. If you do not press the M button,

the meter will beep for 2 minutes then switch off.

If you do not want to test at this time, press the M button

to switch off the meter.

Congratulations! You have completed all

settings!

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

Sem comentários

Vertex Diagnostics UltraTRAK Manual do Proprietário Página 14